de
Menu
de
>auswahl Land×
- NACHRICHTEN
- *** DEALS ***
- PRODUKTE
-
MARKEN
-
ALPINE
- STATUS
- MOBILE-MEDIA-STATION
- NAVIGATIONSSYSTEME
- DIGITAL MEDIA RECEIVER
- AUDI SYSTEMS
- BMW SYSTEMS
- FIAT/IVECO SYSTEMS
- FORD SYSTEMS
- MERCEDES SYSTEMS
- SKODA SYSTEMS
- VOLKSWAGEN
- DASHCAMS
- KAMERA
- MULTIMEDIA
- FULL SPEED KABEL
- VERSTÄRKER
- TYPE-X SPEAKERS
- LAUTSPRECHER TYPE-R
- LAUTSPRECHER TYPE-S
- LAUTSPRECHER TYPE-G
- LAUTSPRECHER TYPE-E
- SUBWOOFER AKTIV
- SUBWOOFER PASSIV
- PROZESSOREN
- MARINE
- AUDIOLAB
- DALI
- FOCAL
-
FOCAL CAR
- UTOPIA M
- K2 POWER M
- K2 POWER EVO
- K2 POWER
- FLAX EVO
- SLATEFIBER
- POLYGLASS
- ACCESS
- UNIVERSAL
- AUDITOR EVO
- SUBWOOFERS
- AMPLIFIERS
- ZUBEHÖR
- PORSCHE
- MERCEDES-BENZ
- BMW / MINI
- TESLA
- VW / SEAT / SKODA
- TOYOTA / LEXUS / SUBARU
- FORD / MAZDA
- RENAULT / DACIA / NISSAN
- PEUGEOT / CITROEN
- HARLEY DAVIDSON
- ACCESSORIES FOR INSIDE
- JL AUDIO CAR
- LEAK
- NAIM
- OPERA LOUDSPEAKERS
- POLK AUDIO
- Q ACOUSTICS
- QED
- QUAD
- RAIDHO
- SCANSONIC HD
- THINKWARE
- WHARFEDALE
- WILSON
-
ALPINE
- OUTLET
- HILFE
- SERVICE
- KONTAKT
- ONLINESHOP
- Power output: 75 watts per channel continuous from20Hz to 20kHz. 1kHz total harmonic Distortion typically 0.6% at 75 watts, below 0.05% at 1 watt. Approximate actual power available at ‘clipping’ 76 watts (1kHz). (Note that actual Power output is dependent upon both line voltage and ‘condition’ i. e.: if power line has high Distortion, maximum power will be affected adversely, although from a listening standpoint this is not very critical.)
- Power bandwidth: (-3dB points) 7Hz to 60kHz
- Frequency response: (-3dB points at 1 watt) 0.7Hz to 75 kHz
- Input sensitivity: 1.4V RMS BAL for rated output. (25 dB Bal Gain into 8 ohms.)
- Input impedance: 300K ohms Balanced.
- Output Polarity: Non-inverting. Balanced input pin 2+ (IEC-268)
- Output taps: 8 ohms, 4 ohms
- Output regulation: Approximately 1.0dB 8 ohm load to open circuit (Damping factor approximately 8)
- Overall negative feedback: 15dB
- Slew rate: 10 volts/microsecond
- Rise time: 4.0 microseconds
- Hum & noise: Less than 0.06mV RMS – 112dB below rated output (IHF weighted, input shorted)
- Power supply energy storage: Approximately 520 joules
- Power requirements: 105-125VAC 60Hz (210-250VAC 50Hz) 410 watts at rated output, 500 watts maximum, 230 watts idle
- Tubes required: 2 – Matched pair KT150 – Power output; 2 – 6H30 Driver