LI de
Menu

18 499 Fr VERKAUFSPREIS

  • Power output: 75 watts per channel continuous from 20Hz to 20kHz. 1 kHz total harmonic Distortion typically 1.5% at 75 watts, .05% at 1 watt. Approximate actual power available at “clipping” 80 watts (1kHz). (Note that actual Power output is dependent upon both line voltage and “condition” i.e.: if power line has high Distortion, maximum power will be affected adversely, although from a listening standpoint this is not very critical.)
  • Power bandwidth (-3dB points): 12Hz to 70kHz
  • Frequency response (-3dB points at 1 watt): 1.0Hz to 70 kHz
  • Input sensitivity: 0.55V RMS Single-ended for rated output. (32.5dB Gain into 8 ohms.)
  • Input impedance: 52.5K ohms Single-ended
  • Inputs: SE1, SE2, SE3, Phono, S/PDIF digital (coax RCA and Toslink), USB
  • Maximum input: 10V RMS (any input)
  • Output Polarity: Non-Inverting (any input)
  • Output taps: 8 ohms, 4 ohms
  • Output regulation: Approximately 2dB 8 ohm load to open circuit (Damping factor approximately 4)
  • Overall negative feedback: 4dB
  • Slew rate: 10 volts/microsecond
  • Rise time: 4 microseconds
  • Hum & noise: Less than 1.0 mV RMS -88dB below rated output (IHF weighted, Vol down)
  • Controls: Rotary volume (103 steps), Rotary input selector, Power, Mute, Bias
  • Digital sample rates: 44.1kHz to 192kHz, SPDIF and USB 2.0 HS, DSD USB 2.0 HS
  • Master oscillator: 22.579mHz ±20Hz for 44.1, 88.2 & 176.4kHz. 24.576mHz ±20Hz for 48, 96 & 192kHz sample rates
  • Intrinsic jitter: <10ps
  • Power supplies: Electronically regulated Low and High voltage supplies for input stages. Automatic 40 sec. warm-up/brown-out mute
  • Power supply energy storage: Approximately 350 joules
  • Power requirements: 100-125VAC 60Hz (200-250VAC 50Hz), 400 watts at rated output, 600 watts maximum, 210 watts at “idle’: 1.0 watt power off
  • Tubes required: 2-Matched pair KT150-Power output; 2 -6H30 driver
  • Minimale Bestellmenge: 1 Stk.
  • PREISE

    DOKUMENTE

    VERKAUF